Home › BRAKE › BRAKE › BRAKE BOOSTER
REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
1.
RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for RHD)
Start up the engine.
Turn the A/C switch on.
Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
2.
REMOVE ENGINE AND TRANSAXLE (for 2GR-FE RHD)
HINT:
Refer to the instructions for removal of the engine assembly. (Click here )
3.
DISCONNECT SUCTION PIPE SUB-ASSEMBLY (for 2AZ-FE RHD)
Remove the bolt, and slide the hook connector.
Disconnect the suction pipe sub-assembly.
Remove the O-ring from the suction hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
4.
DISCONNECT SUCTION PIPE SUB-ASSEMBLY (for 2GR-FE RHD)
Remove the bolt, and slide the hook connector.
Disconnect the suction pipe sub-assembly.
Remove the O-ring from the suction hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
5.
DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY (for 2AZ-FE RHD)
Disconnect the air conditioning tube and accessory.
Remove the O-ring from the air conditioner tube and accessory.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
6.
DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY (for 2GR-FE RHD)
Disconnect the air conditioning tube and accessory.
Remove the O-ring from the air conditioner tube and accessory.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
7.
DISCONNECT BRAKE LINE (for RHD)
Using SST, disconnect the 6 brake lines from the actuator assembly with bracket.
ABS: Click here
VSC: Click here
Separate the brake line from the clamp.
8.
REMOVE BRAKE PEDAL RETURN SPRING (for LHD)
Remove the brake pedal return spring.
9.
REMOVE BRAKE PEDAL RETURN SPRING (for RHD)
Remove the brake pedal return spring.
10.
SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Remove the clip and push rod clevis pin, and separate the brake master cylinder push rod clevis from the brake pedal sub-assembly.
11.
DISCONNECT NO. 2 VACUUM HOSE (for LHD)
Move the clip and disconnect the No. 2 vacuum hose.
12.
REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
HINT:
Refer to the procedures up to "REMOVE MASTER CYLINDER". (Click here )
13.
DISCONNECT NO. 2 VACUUM HOSE (for RHD)
Move the clip and disconnect the No. 2 vacuum hose.
14.
REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts and the brake booster assembly.
NOTICE:
Do not damage the brake lines.
15.
REMOVE BRAKE BOOSTER GASKET
Remove the brake booster gasket.